Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I'm having an issue with routing when it comes to a non-vrf to vrf.
on router1 i can ping and traceroute using the VRF with no problems to the destination subnet.
on router2 it will forward the traffic to router 1 but then just dies there.
...
Hello - I'm making a compliance policy in PI for QoS checking. I would like to create a policy that would look to make sure that QoS is applied appropriately to all of the switch interfaces. Is there a way that PI can do this within the Compliance Po...
Hello - I'm making a compliance policy in PI for QoS checking. I would like to create a policy that would look to make sure that QoS is applied appropriately to all of the switch interfaces. Is there a way that PI can do this within the Compliance Po...
I need to configure a firewall to allow several subnets/vlans through it. I'm having trouble figuring out a way for all of the subnets on one side to go through the ASA. Here is the situation RouterA P2P-> RouterB -> ASA -> L2Switch L2Switch has VLAN...
Switch: WS-C2960X-48FPS-LIOS Version: 15.0(2)EX5Problem Details: Receiving an inline power message %ILPOWER-5-POWER_GRANTED and %ILPOWER-5-IEEE_DISCONNECT for every second of every minute however there is nothing plugged in to the port that is doing ...
Just out of curiosity is there a way to ensure that this runs only on IOS version 15+? Is that done in the report setup when you select the devices, or can you make that in the policy itself?
The reason I'm asking is that the syntax changes a bit be...
