Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I see that the F2e and M1 can coexist in the same VDC, which is a good step forward. But I also read that and L3 functions are proxied from the F2e if there is an M1 present in the VDC. Does this mean that if there is an M1 in the same VDC, an F2e ca...
I've read that the default behavior of an interface on a FEX is to be in routed mode. On these interfaces, do they function just like an L3 interface would directly on a 7K line card? Can you assign an IP address to the interface or must you use an S...
I'm having issues making a connection with my backup ISDN line. I'm enclosing a couple of show commands. I think the bold text might be the issue since I don't see that on any other devices that are working correctly.Does that indicate an issue with ...
You bring up VSS outside of the current environemnt. Create all vlans with a spanning tree priority higher than the existing.Create all the vlan interfaces and leave them shutdown.Connect the existing core to the new VSS core. Make sure that all vlan...
The core switch is a better place for PBR since you can do better manipulation there. You can set up an SLA to verify the 2nd router is up and send the traffic there if it is. If its down, it can route as normal.
It looks like you're trying to redirect the matched traffic back out the same interface it entered on so it can travel to the other router. Is that correct? I'm not sure if that type of redirection is supported with PBR.
If you can have all 4 switches up for the migration, you can do it with almost no downtime, assuming you have your IDF switches dual-homed. As Reza says, you'll incur a pretty big outage if you do it the way you've outlined and you gain very little.I...
