Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, We have deployed ISE 3.0 and using posturing and profiling. Currently, we are facing an issue where the customer is using external connector in Lenovo laptops as those laptops don't have RJ45 connectors.Issue is, when switchport is connecte...
Dear All, We are facing couple of issue at customer end. We have deployed Anyconnect (4.10.x) with NAM module for Cisco ISE posturing.Client has a requirement to connect the corporate SSID when it is in range and when they want to switch to other SSI...
Hello All, I have Cisco IR829. I can see RED LED flashing on WLAN interface, whereas I am not using WLAN. I am using this router for routing purpose, not for Wireless/WLAN. Do you have any idea, why it is flashing and how we can resolve this issue. ...
Dear All,Hope everyone is safe during this pandemic. I have configured Cisco Prime Infrastructure UCS Physical HW Appliance (Gen 3). It is only one appliance.It is connected both (Primary and Secondary) core switches. How I can achieve the redundancy...
Dear All, Can we configure Cisco base wIPS (controller based) to the outdoor mesh ?If yes, what could be the test scenarios ?How we can test it properly, before going to meet the client. Thanks
Dear Georg Pauwen,Please find the output below.TRN-5105-T-CCU-01#service-module wlan-ap 0 statusService Module is Cisco wlan-ap0Service Module supports session via TTY line 4Service Module is failedService Module reset on error is disabledService Mod...
I have IW3702 which is also an outdoor. Can you check, whether it is possible. I have another scenario, where containment is not happening on cisco wlc code 8.5. It is showing, No AP's available for Containment.
How to set boot system parameter before reloading the router.I have upload the bundle image via TFTP. I want to run this new image, but how to set the boot system parameter ?Normal routers are easy to upgrade, here I can see hypervisor, Guest-OS whic...
Hi Leo
Is there any patch or something available ?
If I select the country Israel and time zone too in WLC..will it work?
AP Need to be lwapp not standalone..
