Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have issues upgrading this router due to "not enough space" problems
I was unable to upgrade the running-config tftp
(copy tftp://ip address/c800-universalk9-mz.SPA.157-3.M1.bin run)
so I uploaded the config to Flash (copy tftp://ip address/c800-un...
Hi, I know this question is probably very common but I am still having issues with understanding ACL'sI've read so much documentation but its not helping me understand or apply the knowledge to my situation. basically I have configured a new CISCO 8...
hi hope someone can help.I have a Cisco 887VA router with an active VPN tunnel configured both internet and VPN are up yet I cannot figure out why I am unable to ping an Internet address or a Lan address at the other end of the VPN tunnel from my vla...
hi can anyone help?i have a cisco 887VA router which lost connection to the WAN and I cant figure out whythe Controller VDSL 0 is upthe ATM0 Int is upthe sub int ATM0.1 is downand i am unable to ping 8.8.8.8 from wan interface or lan interfacehere i...
hi I am trying to set up a site to site IPSEC VPN between a cisco 887VA router and a Juniper device in a datacentre and am unable to get the connection to even get past 1st base. it doesnt even seem to even try to connect to the peer.can anyone see ...
I am able to boot into the IOS but only manually from ROMMON the device will not power up into ios automatically. is it something to do with this bootstrap which is still showing the old version how do I change that?
Cisco IOS Software, C800 Softwa...
hino ZBF at the moment obviously I'm going to have to put it back and I probably will use the CCP wizard for that as its lots of lines of code but hopefully it wo't break anything and it will allow for the already active VPN tunnel which is in place...
