Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am working with CUCME and Busy Lamp Field (blf). I am using all SIP phones (8861). I am getting inconsistent results for the busy lamp and I'm not sure why. Sometimes the lamp lights, but not on every phone that's watching. Sometimes the...
I have a 1941 that has high CPU load from interrupts with no traffic. I started out with a clean configuration and it is running IOS 15.8(3)M7. It has about 89% CPU usage even without traffic, but it's almost all interrupt. It has a very simple co...
Hello,I am trying to get the internal access point in a 1941W to work. I didn't have the original configuration, so I reset the configuration on the 1941W and got that going. For the internal access point, when I connect to the console and try to l...
Hello, I just set up a Cisco access point with autonomous IOS firmware, and I am having problems with Apple iPhones. After some period of time, the 802.11 no longer works, but the Apple device says it's still connected. It doesn't work again until ...
I have VPDN set up on a router with IOS 15 also running overloaded NAT (PAT). The tunnel is L2TP/PPTP. VPN is currently split tunnel and working. I need to enable full tunnel. When I changed the tunnel on the client side to route everything throug...
No, I didn't have device at the end of those blf configuration lines. I just added and will test. Hopefully that was the missing element. Thank you, I'll report back on whether it works after that change. Not sure if I'll have to reregister the p...
Hello and thank you both for the responses. Carlo, I activated debugging and terminal monitor and did the handset pickup on 101 and there was no output:debug ccsip non-callSIP Out-of-Dialog tracing is enabled#sh debug CCSIP SPI: SIP Out-of-D...
