Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are designing a network for open stack based cloud. If we use ACI as an SDN solution for open stack, do we still need the open stack switches or ACI will completely replace it ? To be more precise we will be using ACI to provide external conne...
I am trying to establish qinq over atom between 2 ASR-1001x running mpls in between. Everything comes up after configuration but I am not able to ping each other. At the same time layer2 mpls- atom with single vlan is working fine.
Instead of t...
I am working on N9K-C93240YC-FX2. But I am not able to save the configuration in switch. Please find the below result.
[########################################] 100%Configuration update aborted: request was aborted
Even I cannot upgrade the NX-...
I am trying to connected Fabric extender N2K-C2332TQ-10GT to N5K-C5672UP. But the fex state is showing offline. Can any one please help me to fix this issue
I am using QSFP to connect from N5K to N2K
Please find the below results
sh fex FEX ...
I tried the below solution and works fine (link attached)https://ipnet.xyz/2026/01/installing-cisco-nexus-dashboard-on-proxmox/ . I made some changes to the VM specs as attached . While creating the VM, use the processor type as host . The CPU 16 cor...
I would like to add couple of more thing. The MTU of the path in between is 1500 and there are some hardware in the path which doesn't support qinq .
Does it make any issue ?
I am new to nexus, so i dont know how find the M/F series module connected ? I am using N5K does this applicable to to 5K or only for 7K.
sh moduleMod Ports Module-Type Model Status--- ----- ------------...
