Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone confirm if a breakout cable is supported by the S3260 storage server with an embedded VIC1300? This will uplink to a 6454 FI. The datasheet and spec sheets don't seem to confirm this detail.
I've got some C220-M5's running 4.0(4c) firmware with a fresh install of vSphere 6.5U2 (Cisco custom). Also using VIC 1457. I'd like to use the 2 onboard 10Gbase-T ports for management traffic on the ESX hosts. The problem is that only the 4 MLOM (VI...
Configuring site-to-site IPSEC VPN. In ASA, you're able to have multiple IKE policies but I don't see that option in FTD. It appears that you can only select one at a time.
I see the following text from the FTD 6.2 Configuration Guide:
"IKE policie...
I've got a 3750X that I would like to rate limit backup traffic destined for a remote site. I've defined my source IP addresses using an ACL and class-map. The issue is that version 15.X doesn't seem to support the "shape average" commands. I've been...
I'm struggling to remember where I saw this but I believe I read that the "uplink" 40/100Gb ports on the 9300-EX switches can only be used as uplink ports to upstream switches and not to any host-level or VPC connectivity. Maybe I'm dreaming this. Si...
To clarify, you were able to successfully get a GLC-T to work in in a 9500-32C switch using a CVR adapter module? I just checked the compatibility matrix tool & its not showing that the GLC-T is supported in either the 9500-32C or 9500-32QC.
Wes, the type of optic isn't set in stone yet but we are considering a QSFP+ breakout cable. Based on that compatibility matrix you shared, it looks like it will work just fine with the 6400 FI. Thank you for sharing that. I did a lot of searching bu...
Viewing the uptime is a very simple feature that absolutely should be included in the Dashboard. The problem with some of your arguments about Meraki is that many of the Meraki SE's & sales folks that I've encountered position this as a legit enterpr...
One other thing to be aware of is that different line cards have different VDC port groupings. You can check the following doc for more details on that.https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/nx-os/virtual_device_context/configur...
