Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a storage device that needs to receive connections from a VM in vmware.Since the communication is layer 2 I reached a problem where vlan pools overlap between the EPGs since the physical domains are different. Which would be the best solution ...
I need to connect 2x non-cisco layer 2 switches to ACI which itself will serve as the gateway of multiple vlans/ranges running there.There's no need to extend the layer 2 domain as it will terminate in ACI and then it's just transit routing to the Fa...
Did the upgrade of a pair of 5548UP to 7.3(7)N1(1) The pair was upgraded but the FEXes don't show up.Physically they are are blinking green, all ports amber expect the uplinks that are turned off. From the 5548UP the downlinks are not connected and s...
I am having a switch with constant output drops, however the bandwidth usage is low for the interface.
This is just a trunk interface, what could be causing the switch to drop so many packets? Is there a limit of the number of packets per interface?
...
Hi all, in 1 topology I have an OSPF LSA from a decommissioned router that is not reachable anymore. #show ip ospf 20 database network 172.31.171.5 OSPF Router with ID (172.31.170.1) (Process ID 20) Net Link States (Area 64.0.0.20) ...
Hi @Sergiu.Daniluk thanks for your tremendous help.May i know why the 5th layout is not supported?Common BD for 2 EPGs with different physical domains with local scope?
it turns out we hit this bug https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvt58479so watch out folks, be ready to downgrade quickly if you experience this too.
I was just reading a previous post of yours:
On the 3750 series, when dealing with bursty traffic, I've had great success by tuning the hardware buffers. Basically, rather than using the defaults, which reserve 50% of your buffer space to interface...
Thanks for the help Josep and George.
I have got one question though, if you are dealing with a situation where it's not just bursty traffic, the switch is constantly having discards out or output drops due to excessive amounts of packets having to ...
QoS is not enabled in the device
I understand what probably is happening the hardware queue for this interface is always full, for this kind of traffic. Is there a way of making more buffer for this queue of traffic while sacrificing a little from th...
