Appreciate any suggestions and/or direction on how to begin to troubleshoot this error for an FXS port in CUCM for a Cisco C8300 router with a 24 port FXS module installed:Product Cisco MGCP FXS PortGateway aaa-bbb-vg.net.xxx.comDevice Protocol Analo...
Hi Cisco Community Members, We ran into these interesting logs on one of our VG224s and was wondering if anyone knows what this is? Is someone or something actually shutting down and then immediately bringing these ports back online? xxx-xxx-xxx#sh h...
Hello,
Can anyone tell us how to enable and then where to navigate to, to find the Remote Destination options on the Self Care Portal of CUCM for End User Options?
Thanks,
Tom
Hi There,
Could anyone shed some light on this question. What happened to the Primary User Device field in CUCM 10.5 under Mobility Information in the End User's configuration page. It existed in 8.6.
Thanks,
Tom
It appears that it did not matter, at least for us, which device to pick on the drop downs when configuring the 24 port FXS module as a separate device in CUCM using the SCCP protocol.
Hi Nithin,Thanks for responding. The problem, we believe, is with these new C8300 routers that in Call Manager, two gateways needs to be configured. One with MGCP for the router itself and if it has a NIM module installed the PRI and/or POTs line con...
"clock source line [primary|secondary] Configures the clock source of the backplaneclock source network Uses the backplane clock or the oscillator clock as the module clock sourceNote: The command 'clock source internal' is used for data transmissi...