Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If UDLD is enabled under fiber ports, if loop accurs/detected with one of fiber link in EtherChannel, would the whole EtherChannel will go down/error-disbaled or would only down the specific port will go down in EtherChannel ?
As i am new to Flex connect /WiFi, i was trying to understand flex connect and then i found attached from official docs. My confusion, indeed security in shape of vpn in regards of remote AP's to communicate with controller in HQ. what if we have ...
Hi All,
I have one 2960 and one SG-300-20 switch:
- Need to configure trunk ports between them
- Need to configure managment vlan (10) and svi for management vlan on SG-300-20
- Need to configure data vlan (20) and svi for data vlan on cisco SG-300...
Can we use two fast hello links between two chasis because i am going to put 4 links in vss from two modules (supervisor engine and uplink module) within a chasi to other same side supervisor and uplink modules? like I want to make one Fast hello fro...
Hi,
I face a problem today regarding channel-group mismatch.
*Feb 25 13:23:40.107: %PM-4-ERR_DISABLE: channel-misconfig (STP) error detected on Po10, putting Gi1/0/1 in err-disable state*Feb 25 13:23:40.111: %PM-4-ERR_DISABLE: channel-misconfig (ST...
Thank for the reply. That is what mention in cisco doc for recommendation as i mention i am new to this but what if we don't have site to site vpn or MPLS i mean what if we have only flat internet connection and required flexconnect need to manage or...
Thanks Reza as you are helping me alot i have one more question hopefully last one, As my VSL is up and running now i have been told to add additional link from other module into VSL (etherchannel) on both sides. Shall i add just that additional link...
Thanks Reza, i will give a try for this. Other thing i need to clarify is, i know i need only one Hello link but what if i can use two Hello links as mention in the topology. Is it not good incase one of my Hello Link goes down?
Hi Anand
Can we use two fast hello links between two chasis becouse i am going to put 4 links in vss from two modules (supervisor engine and uplink module) with in a chasi to other same side supervisor and uplink modules ? like i want to make one Fa...
