Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After reimage access point from CAPWAP to EWC.
Initial CLI Configuration and Web UI Wizard are both not available.
show version
AP Image type : EWC-AP IMAGE
AP Configuration : EWC-AP CAPABLE
Hi All,in document 'Cisco ASA 5500 Series Configuration Guide using the CLI' it mentioned, If a unit boots and detects a peer already running as active, it becomes the standby unit.My situation is FW1 is set as primary, FW2 is set as secondary. When ...
Hi Tech, I have a few AP join to mobility express (ME) controller (on one AP point) and they could manage through one static management IP.the question is. How could i monitor the status of each Access point through SNMP?I could monitor the status of...
hi all,
Is the firewall ASA version 9.8 gigabit interface port number is change to starting from gigabit 1/1...gi1/8 instead of last time start from number gi1/0?
thank you.
Hi all,
can anybody advice how could I check the quantity of CME-UL license I purchase?
when I use show license, it doesn't show the user license. how can I know what is the maximum user license is supported? thank you.
UCME#show licenseIndex 1 Fea...
hi, i have the same scenario where 3850 act as WLC and AP connect to 2960 switch. the AP cannot join the WLC now. I had enable the license and configure on my 3850 wireless mobility controllerwireless management interface Vlan10wlan SSIDA 1 SSIDAcli...
thanks for this information. I also configure this firewall to switch trunk port with spanning tree portfast trunk.However, sometime i encounter the error disable (sometimes) on that switchport. i manually shutdown and no shut again.any expert have a...
Hi,
I could only found the antenna extension cable with tnc connector.
However the antenna I use is N connector (AIR-ANT5180V-N &
AIR-ANT2480V-N), is cisco have any extension cable with N connector? or adaptor for it?
thank you.
