Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have configured radius on some N5K-C5672UP switches. Running 7.3(13)N1(1).
I can login using my AD credentials but for some reason I seem to have a reduced privilege level and cannot see all commands when doing a conf t.
L1N5K02-P(config)# ?no ...
Hi all,
I am having issues when attempting to configured Radius please see below..
L1N5K02-P# conf tEnter configuration commands, one per line. End with CNTL/Z.L1N5K02-P(config)# no fips mode enableFIPS mode is disabledL1N5K02-P(config)# radius-serve...
Can anyone confirm the impact on wired dot1x client connections and current load when performing a split upgrade and whether the one ISE node can handle traffic during upgrading the other? If not how do I confirm this?
Hi all,
I have applied STP to interface 1/34/1 and attemping to use 1/33 as the default path for traffic, it is still showing BLK... any suggestions.
conf interface e1/34/1spanning-tree vlan 104 cost 2500spanning-tree vlan 107 cost 2500spanning-tre...
This guide states the 5500 series has sampled netflow but I have no feature enable netflow/sflow/flow exporter commands or commands for either within conf t
https://community.cisco.com/t5/security-knowledge-base/netflow-support-matrix/ta-p/3644638?at...
No difference. Radius is working for another device and I can see the full range of conf t commands but on the device is question I only see a few. I am unsure if this is a NPS issue or more a switch issue...
Yes there are 3 values in the 5000 attribute. Should it only have the shell:roles*\network-admin\ and remove the priv 15 and other shell role value? I thought you could have more than one value in the 5000 attribute..
Hi,
I have removed the network operator but is this required as on the switch it states my account is a network-operator. Should this be matching on NPS and switch?
roles:network-operatoruser:mike.allen_adm
