Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have to capture traffic and I wish to apply the VACL Capture as described in the doc "VACL Capture for Granular Traffic Analysis with Cisco Catalyst 6000/6500 Running Cisco IOS Software"(http://www.cisco.com/en/US/partner/tech/tk389/tk689/techno...
One month ago, I have moved the serial connection of the remote router RR from the local router R3 to the local router R1. I also dismissed R3 and I deleted it in CWorks 2.5.1.Now if I request to show the RR in Device Center, the CDP neighbors list i...
I have CW2000 LMS 2.5.1 on MS-Windows 2003 server and I have scheduled a daily backup, but it does not start.In the dbbackup.log file I've found the following error message:ERROR(992): Fatal error: Database engine 'dfmInvEng' could not be started on ...
The question is: how can a Cat6506-IOS send through CDP protocol any of its configured IP addresses instead of its SPV loopback address?The scenario is: a Cat6506 SPV2-MSFC2 with IOS version 12.2(17d)SXB10 connected through a WS-X6516A-GBIC interface...
Hi,I am managing a couple of Cat 6506 IOS.I can reset or shutdown a linecard (e.g. a NAM) using the "hw-module" command; does exist any command to power up a shutted down line card?Best regards.Paolo Calcaterra
Hi,I had some similar problem with CDP on 650x and trunk links. Mainly the problem is related to CDP that communicates only using VLAN 1, so if the VLAN 1 is removed form the trunk the CDP works oddly.I didn't have any experience between 650x and 375...
I do not think that the Solaris vs. Windows2003 could resolve anything.Anyway, waiting that Cisco Corp. will answer to these posts, I wish to share a couple of evaluations about LMS 2.5.1 bugsThe main issues are about the DBs: they can get some odd s...
Hi, your problem is caused by CDP and there is a discussion about in the "LAN, Switching e Routing" section.Please look for the topic "Cat6500 IOS: cdp neighbors on trunk without vlan 1"Regards. Paolo C.
Thanks Ankur,the 6500 CDP problem is regarding which IP is elected by the IOS as "management address" to distribute via CDP: I think that should the first Loopback interface address to be elected, and this is the behavior in the old 12.2(17d)SXB1 IO...
Thanks Michel,the backup dir is in another drive (C:, CSCOpx is in E:) with enough space left (about 4 time the needed).Anyway, after a deeper analisys of the dbbackup.log file, I figured out that the backup started, but due to the "ERROR(992)", the ...
