lonelyadmin
Level 1
Level 1
Member since ‎10-06-2017
‎07-21-2023

User Statistics

  • 35 Posts
  • 1 Solutions
  • 5 Helpful votes Given
  • 15 Helpful votes Received
Recent Badges
First Discussion
5 Discussion Posts
5 Helpful Vote
30 Discussion Posts
20 Discussion Posts
15 Helpful Vote
10 Discussion Posts
1 Reply
10 Helpful Vote
1 Helpful Vote

User Activity

It's been so long since I worked on this 2504 I think I've forgotten everything I knew...I have several SSIDs broadcast on all APs. Using default config on everything for the most part. All are currently part of the "default-group". I need to only br...
Working with 4500X and 2960X switches. I have HSRP running on all of the L3 interfaces, mostly vlans. Is there a way to not send HSRP broadcasts down every interface and only limit it to interfaces connected to other switches?  Everytime I startup wi...
New to the 9200X line of switches. I'm trying to figure out the best way to uplink a single 9200X to two seperate 4500X switch stacks. Links don't have to be active/active load balancing (though that's preferred). If approach is active/standby I'd ne...
I have 2 4500X VSS stacks (4 switches total) connected by a 4 port trunk...nothing exciting, it works fine. I need to uplink a few 2960X's (also stacked) and I'm looking for documentation on if I should split the links between the stacks or have the ...
I'm installing a few WAPs in very difficult to reach locations. Does anyone have any recommendations on a remote serial console device I can connect to the serial port on the WAP that I can run an extra cat6 cable to at the time of install? I'd rathe...
Community Statistics
Member Since ‎10-06-2017 01:40 PM
Date Last Visited ‎07-21-2023 12:02 AM
Posts 35
Total Helpful Votes Received 15
Helpful Votes From
Helpful Votes Given To