Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!
I have this strange issue where calls are getting stuck as shown in the screenshot and all I could find is an RTMT trigger error.... that I can't seem to nail down. The config is there and looks good. I'm running out of ideas. I have reboote...
Good Morning!
I am looking for a little guidance for how to integrate this piece of equipment into my network. I have a new 2821 router with Call Manger Express and CCX 50 user bundle. I am new to the Cisco voice systems and am building a system to...
Hi Folks,
I am hoping someone can help me here. I have a AIR-LAP1142N that was pulled out of a network managed by a controller (lightweight?). The controller disappeared (walked out the door). I am trying to refresh it to the autonomous firmware so...
Hello Everyone!
I have an ASA with a SSM-10 installed and a trial subscription for the IPS module. The license is valid, however I am not getting signature downloads and I get the error below. The IPS version is 7.1(9)E4. I have the external port o...
Jonathan,
Thanks for the reply!
I will be using SIP for PSTN calling. So perhaps I should put in on a DMZ port on the ASA like shown below? Then just create the necessary rules and open ports to allow SIP traffic in and out? That way it is isolat...
Leo,
That is correct. However it is constantly changing IP addresses every time it tries to find the controller and can’t. Is there a way to make it static on this thing?
Thanks!
Marvin,
May I ask you a follow up question? Is there a way to do bulk signature updates? So I now have a folder full of all the updates since 814.0 and manually updating each one is a pain. If it is smart enough to grab what it needs from the web.....
