Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have to deploy four B200 M5 blades in a domain with 6248 FIs running 3.2.3k. I have to deploy them as Vm hosts running esxi 6.7 u3. Going by the Cisco HCL, I will need to upgrade my FIs to 4.0.x minimum which I plan to do but I have to wait until w...
I added two new vNICs to 12 service profiles. 10 were B200 M3s and 2 were B200 M4s. Two of the M4s after making this change take an extremely long time to boot and when up have lost all config. They don't have their datastores and are missing their b...
We still have some B230 M2s in our domain which we recently upgraded to 3.2.3k. These B230 M2s have VIC 1280 which is supported on this FW version according to the HCL. I associated the Host Firmware Policy with the service profile and this blade get...
I have set and changed user labels and descriptions in service profiles before but never noticed anything but this time I looked at the FSM tab and saw power action events. According to the SP FSM it looked like it was rebooting the blade which doesn...
I have a stupid question but better safe that sorry. We have some standalone C240 M4S servers with cat 5e cables pugged in the CIMC interface. We have to disconnect them so we can re-run those cables for better cable management. I am pretty sure it i...
Oh man, that is a real shame. I didn't get any notifications from UCSM that these changes will require a reboot and there is no pending activity. Just those entries in FSM. I really cannot reboot these hosts as they don't support vmotion at this time...
Thanks Kirk but I didnt touch the asset tag field. I only changed the User Label and Description fields. That should not trigger or require a reboot right?
