Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Our current FMC is managing 2x FTD 2110 in HA pair. The standby FTD suddenly went dead and Cisco has provided us a new FTD via RMA. Before the FTD went dead, we were also planning to migrate our FMC to new physical server(because it was having l...
We have ASA5545-X with SFR module installed. i need to upgrade ASA software from 9.5 to 9.8. and i want to do the upgrade only on ASA. while i dont want to make any change to SFR.
i am confused whether upgrading ASA software will have any impact on...
Can some please help me understand following ACL. object-group service SERVICE_Object service-object tcp eq 30175 service-object udp eq 30175 access-list OUTSIDE extended permit object-group SERVICE_Object 1.1.1.1 2.2.2.2 is it 1: any traffic from ...
Hi Guys,
i am relatively new to firewalls (both ASA and FTD) and having few queries related to this migration.
i am migrating from ASA 8.2 to FTD 2130 (via FMC). Since there is no automatic migration path, so i am doing all my migration manually. ...
i want to come up with a BOQ for unified contact center express 8.5 10 seats minimum. system should include call recording feature. Can CCX 8.5 be integrated with CM 7.1. following are the part number i have a) CCX-85-SRVRS-MEDIA CCX-85MEDI...
Why dont you re-image the ftd with desired version instead of going through multiple upgrade processes. Re-imaging will be quick and clean. All your policies stay with the FMC anyway, just re-deploy them after re-imaging. You would just need to reco...
Thanks Marvin, When you say "register the new one prior to deploying and policies" do you mean we should do that right before step 4?? Actually our plan is to enable evaluation license so we are able to register FTD, Push policies and verify. once do...
I hit the same issue last week. same scenario as Florin had.Site A: FTD behind NAT deviceSiteB: Palo AltoSA state : MM_WAIT_MSG6 ( verified PSK, no issue there)Did Debug on PA side, found peer identity wasn't matching because FTD was sending Private ...
Hi Leo,
I am going to do software upgrade from 3.9.00 to 3.9.2.
My 4500x are running in vss.The default config-register is 0x2101 (i thought the default is always 0x2102).
Things not clear to me are
1: is there any difference between 0x2101 v...
Hi parmasirid,
just a question..
While registering FTD with RADIUS server (assuming ISE), what ip should be provided to radius server, management IP of device or any data interface (inside/DMZ)??
Regards
Aurangzeb
