Hi all,
I have the following issue.
I'm connecting an iw3702 ap directly to a WS-C2960S-24PS-L and nothing happens, the ap never comes up.
If I take the same ap to a different switch in another location it turns up well and register on wlc without a ...
Hi guys, I had been asked to monitor some resources in servers with the HUM module but I am not sure from where could start the research. Can someone point me the right direction or tell me if you made something like this before? This is ...
Hi guys, First of all please forgive my ignorance, but could someone give the specific difference between Alert and Event in DFM. I understand that an event is something that I can define specifically, but what DFM considers an Alert? There is a ...
Hi folks, I'm having this issue since I update the IOS from 12.4(9)T to 12.4(24)T2. So I tried 12.4(22)T, 12.4(20)T, 12.4(15)T. With every version the problem is always the same (reboots continuosly).Then I had back to 12.4(9)T and the router sta...
I will double check with people on site about physical connectivity.It's supposed that the AP is connected to the switch with rj45/m12 patch cord right now. So the length should be 3 meters.I let you know any news.Thanks.
Leo,
Thanks for your help, below the output required:
2960Sw-01#show cable tdr interface gi1/0/23TDR test last run on: July 09 12:28:04
Interface Speed Local pair Pair length Remote pair Pair status--------- ----- ---------- ------------------ ----...
Thanks for your reply.The primary goal behind this pollers are not real-time graphics monitoring but possibility to create thresholds e-mails alerts in case of status changes (down of course).About the use of Nagios, my customer wants to use one plat...
