Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a way to setup more than one access # for Unity? We have a main # (1234) to access the opening greeting, but I want a # (1235) we can call that will ask for an extension. For example - a caller would ask me to be put into someones voice m...
We have a little bit of a debate going here!We are replacing our Voice Mail with Unity as a first step to a final VoIP solution. Should the PIMG gateway routing point at a specific IP address (the Unity server) or the 9001 # listed in the Cisco docu...
I'm looking for a good reference guide for CCM and Unity. I need to look up descrptions or definitions of features as simple as "what is a closed message used for?". Basically information an Admin would get from new end users.
Does anyone know of a good Testing / Troubleshooting guide for SSO Redundancy.I have searched CCO and not found what I wanted. I have a 6509 with two Sup 720's.Thanks in advance.
All of my 6148A modules show "down" in CiscoView. Is there a new package that supports these modules? I downloaded what I could today but this did not fix my problem.
Hi Nick,Funny that you mentioned T1's slips and packet loss/jitter, that is where I was starting to look for problems. I will keep a close eye on those. I also noticed we can not set network clock on the VG224's like we do on 3845 gateways. Is that...
Hi Nick,I am also having intermittent fax problems.We have high volumes, usually 500 plus faxes per day. About every 2 weeks we get between 5 and 10 complaints of "incomplete" faxes. For instance: it should be a 10 page fax... we get 5 pages, but ...
Hi Frank,afaik, the best practice for setting switch ports is to use auto/auto.Not sure why some of your phones seem to work and some don't. The way you describe your setup, all of your phones should have duplex mismatches. If you hard code your s...
