Hello,I've got two new CSS, but when I start them, no prompt appears at terminal-console.I checked my cable, my PC, all...Is it possible a battery problem?Thank you in advance
Hello,I've got a Cisco 3550 12G.Suddenly the GigabitEthernet0/4 goes down and goes in "err-disabled" mode.I think to have fixed the problem (probably a bad cable).Now: how can I re-enable the port?With CATOS I think "set port enable", but with IOS?Th...
Hello,we're upgrading ICM from 4.6 release to 5.When we try to install ENTERPRISE AGENT SERVER on AW (Administrative Workstation) from the Third Party CD, AW notify me with the error below:"java.sql.SQLException: JZ006: Caught IOException "Could anyo...
Hello,this is a simple question.If I enable outside connection to an inside server with this static:static (inside,outside) tcp 100.100.100.100 80 10.10.10.10 80the server will also be able to initiate tcp connections from inside (LAN) to outside (In...
Hello,thank you for your link.We tried to make a cable as showed, but we are able only to see the "rommom>" prompt... we're not able to send keystroke.It seems the cable can only receive, but not send.We have remaked the cable two times, so I think t...
Hello, thank you for the answer.My CSS is an old CSS-11051-AC, so I think I need to use the console cable you suggested me...We've lost that cable, so I'm looking for a new cable or a pinout table.Thank you again.
Hello,I shutted down/up the interface. After I have configured the "errdisabled recovery ...", but my interface is now in the "notconnect" status with both interface and line protcol down:=== sh int ===GigabitEthernet0/4 is down, line protocol is dow...