Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone help me in setting up QoS on a Cat 6506 and on a Cisco 3825 Router for VoIP. The CM/Unity/IPCC are all one VLAN. Could Auto-QoS be an alternative if I do not want to deal with manually configuring the switch & the router.Pls advice.Thx
Is there an equivalent command in Cat IOS for "show log command" when used on a Cat OS switch. I recently integrated a Cisco 6506 with Cat IOS on the network & want to track all the commands that have been entered by all who have access to the switch...
Diagnostic sanity check on the 6500 reports Invalid boot image "bootdisk:<output omitted>The boot statement on the 6500 is :- boot system bootdisk:<filename.bin> and the 6500 boots fine. Please advise.Thank You.
Hi,I am trying to nail 2 async lines using the "autocommand telnet x.x.x.x {port number}" format, but although I can ping the remote IP address, the lines do nail up when I do a "systat" on the routers....any help/ideas on this would be great. The po...
Thx for the link but seems that the tool wants the entire config file. I entered the Cat OS command hoping for it's equivalent IOS command...unless I am doing something wrong. Pls advise.
I checked the SP ROMMON version on the SUP 720 & it has the correct release, 8.4(2)Let me see if works if I change the boot sequence to sup-bootdisk rather than bootdiskThx for the all help
It's running IOS 12.2(18)SXF4. show sup-bootdisk shows the code listed but show diagnostic sanity lists it as an invalid code. Not sure if it's a bug issue or something else.
The idea of HSRP works properly when you have 2 routers, thereby creating a vitual IP between 2 physical IPs. Also, you would need to HSRP to track/sense your egress interfaces, so when the active router goes into standby, there's minimal packet loss...
