Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi! Could anybody tell which service contract should customer buy to get replacement, hardware/software update and support for the1. MCS7835H1-K9-CM50 HW/SW Unified CallMgr 5.0 7835-H1 Appliance, 0 Seats2. LIC-CM5.0-7835-H1= License CallMgr 5.0 7835-...
Cisco CME supports only phones that are local to the Cisco CME LAN and does not support remote SCCP phones that are connected across WAN links. http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps5207/products_administration_guide_chapter09186a...
There's Cisco 2811 with CME connected with Siemens PBX over E1 with QSIG signaling. Some Cisco ip phones are connected to CME. PBX sends caller-id to Cisco( shown in tracer on PBX), but it's not displayed on the ip phones.When call is between ipphone...
Hi, Everybody!AIM Modules use IP Payload compression protocol ( rfc 2393 ), but I cannot find Which compression algorithms can be used with AIM Modules for 1841?How helpfull could it be while using 2 Mbps WAN connection?Thank you!
What could be a reason of following messages:12-29-2005 13:59:49 Local7.Critical 172.30.0.54 2564: -Traceback= 1A57D01A6DF4 161B3C 1B2BF0 1B2D60 1C644012-29-2005 13:59:49 Local7.Critical 172.30.0.54 2563: -Process= "PoolManager", ipl= 0, pid= 512-29-...
In other words caller-id is not displayed when call is originaly from any phone that is connected to PBX. While caller is is displayed if it is originaly from any phone connected to Cisco router.PBX and Cisco are connected through QSIG+PRI, debug at...
thanks for a very usefull link. one more question: in case two ISPs with only one ip per interface how is it possiable to use NAT?interface fast ethernet 0/0/1...ip address 192.168.1.1 255.255.255.0ip nat inside!interface gigabit 0/0...ip address 1....
