Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking to implement temporary GuestWireless Design prior to while the ISE deployment is in procress. Went with NextGen networking for WLC 552 and AP 3800. Since the WLC dos not support DHCP does anyone have any suggestions for GuestNetwork design. W...
I'm looking for ideas on how to have complete HA between a dedicated T1 and an L2L VPN over the internet.We had discussed routing protocol OSPF but would like to avoid the converge issues that could rise and affect other customers in the same DMZ.Wha...
We?re looking for software that will help us audit and keep track of firewall policies. We are constantly doing audits on our firewalls, whenever there is a change. We would also would need to link to documents to change control documentation unles...
Does anyone know if the process of creating phase 1 and phase 2 is a stateful connection or does it create a new connection somewhat like FTP?Do you have link explaining it?I have 2 firewalls, firewall A is Inet EDge, Firewall B is the VPN box.Firewa...
I have been wrestling with the best design for my network. I would like to take advantage of the MLS features of a 4506 but want to pass the traffic through my PIX. I would like to minimize the vlans needed off the PIX and have the routing take pla...
I had to revisit this configuration. I had decided since we are not going to use a routing protocol that a floating route between the T1 router and VPN is the best solution. although this should work if the router or Ethernet of the router goes down ...
Yes this is possible. We are currently using the same design.http://www.cisco.com/en/US/products/hw/contnetw/ps792/products_configuration_guide_chapter09186a0080579f6b.htmlPlease rate.
