Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have multiple EEMs configured on an ASR1002-X machine. However, they are not executed when the conditions occur. I have already validated the EEMs and they are correctly configured. Reading in documents I see that my team has a full EEM queue and ...
A 6500 computer restarted unexpectedly and with the Show version command it returns the following:System returned to ROM by power cycle at 19:20:01 UTC Wed May 31 2017 (SP by power on)System restarted at 10:11:39 MEXICO Thu Aug 27 2020Last reset from...
I have received the following messages on an N5K-C5596UP device:% NOHMS-2-NOHMS_ENV_ERR_TEMPMINALRM: lower system temperature alarm in module 1. SensorThe exit crossed the lower threshold 58CThe output of the "show environment temperature" command is...
I have several N5K devices, one of them is diagnosed as being affected by this ERROR although it has version 7.0.(5)N1(1) which is not documented as an affected release. The question is, is any N5K platform with a different version than those indicat...
Team. The device continues to present the minor alarm, validating in a monitoring tool there are 82 times that these alarms have been presented, the last one was since 07/18/2020 and since then it has been present.It has already been validated that t...
The temperature is valid in the DC and is the same that is injected to all equipment. The temperature is valid by command in 3 other devices and is OK.The equipment 1 is the only one that presents these alarms, according to this alarm the equipment h...
@Julio E. Moisa ha escrito:You should verify the temperature into the Data Center, front of the Nexus. It could be a cosmetic bug. Check the temperature on your Nexus switches, it should be similar. The temperature in the DC is the same in all the r...
