I have loaded the Cisco VPN Client (3.5.2) on a Mac G4 w/ OS-X (10.1.5). Loaded as per instructions on CCO. When I attempt to run from user prompt in terminal window (using "vpnclient connect macclient.pcf"), I get the following error:Cisco Systems V...
I have some instances of old (primarily test) servers showing up in my CM admin page. When I try to delete them, the system tells me it cannot contact that server and/or that server still has items associated w/ it. I have searched every page and can...
I need to configure a fail over for my WAN link. I have a modem and/or multiple modems hooked up to every router in my network. What I would like to do is to program the serial interfaces and/or the aux port to automatically dial the main frame route...
Can anyone point me to the documentation on how to make Netmeeting, Outlook 2K and the IP phones work together? I am using 7940s & 60s, CCM 3.1(2c), and VG200s. Thanks.
Yes, I have done all of that. I am still getting the message:"This DNS/IP Address cannot be deleted because it is in use by one or more devices. Remove the DNS/IP Address from any device that is using it, then try again."Question is, how can I tell w...
In my experience, you have to have the entries in you LMhosts file correct. Also, you should us IP addresses in the enterprise parameters, vs. DNS names. Hope this helps.
Rob, Could you possibly send me a sample of how you did this. I would be very interested in seeing what you have set up. Thanks.Ross Rehartrehartr@quadrep.com
I have been doing this for about 9 months now. It works great on Cable Modem, DSL and ISDN. The only thing that you have to watch for is bandwidth utilization. I have had up to 3 phones on a cable modem, and have also created an MGCP gateway (using a...