Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a sample script or a way to ask a caller to key in a number string to call out a pager from an attendant menu? Example:Call comes in to 800 number and the script detects that the call is made after hours and one of the prompts is to page th...
This is probably a silly question, but we recently stopped being able to check voicemail dialing an outide number (PSTN number)to our CME/CUE system. However, I am able to get the voicemail prompts if I dial the internal number 1000 from one of the ...
We just tried to upgrade our phones from a 3.2.2 firmware image load to a 5.x. We copied the 5.x .bin firmware files to the 2650 router and had the phones go through the upgrade and now the phones are coming up with an invalid protocol message on the...
We just tried to upgrade our phones from a 3.2.2 firmware image load to a 5.x. We copied the 5.x .bin firmware files to the 2650 router and had the phones go through the upgrade and now the phones are coming up with an invalid protocol message on the...
I am trying to connect a cisco router 2650XM with CME to a cat4006 sup II and a L3 card with 7940 phones. Does anyone know what is the best way to configure the Cat4006 for voice? is there a good document that explains how to connect the router (tru...
I got it to work by creating a menu option with an input variable that calls an outside number (the pager) can CCME create a script to send an email alert notification when someone leaves a voice mail. Thanks
When I tried to do just that I got the following:router(config)#no in Serial1/0:23% Removal of channelized E1/T1 interface configuration is not permitted. Remove timeslot configuration on controller to remove Serial1/0:23 interface.router(config)#in...
What happens when you have half a PRI? does it mean you then have 12B channels and 1D channel? if so, how would you define the 12 channels and a D as the 13th on a Cisco 2651XM router?Everytime I try to define 13 channels (12B+1D) timeslots 1-13 I g...
We are running catOs 5.5.4 or so and Version 12.0(7)W5(15b) on the L3 router blade. Is there a good version of both cat Os for the switch and IOS for the router blade I should upgrade to before attempting to make it work?Also on the vlan configurati...
