Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working with Cisco ISE and need to add different devices for Tacas monitoring.The switches that I must add are all on the same segment.For instance:192.168.0.4/24192.168.0.5/24192.168.0.6/24192.168.0.7/24When I try to add them individually ISE i...
Hello,I am adding a cisco IE4000 switch to a Ruggedcom switch topology, the goal is to change all ruggedcom to cisco in the short term.The problem occurs when I replace the first switch, when connecting the Cisco switch to a Ruggedcom switch, the lin...
I have all the devices on the same 192.1680.x network.According to what you indicate, I should add an entry for each switch, but with a / 32 mask, right?Is it normal that they should all be added with a / 32 mask?I don't have much experience with ISE...
Hello,I found the problem, I found that even though both switches have RPVST apparently it is not compliant, change only the cisco to PVST and and kept the ruggedcom in RPVST and the problem was solved.
Hi, I have others connections on the cisco switch, but I also tried using only that connection and the behavior is the same, the interface continues in BLK
Thank you,I tried the command in the documentation on the firewall to validate the policies and they work on the firewall, but not from the PCs I don't go through the firewall.I think I have a communication problem between the switch and the firewall...
