Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I just thinking if i can connect two of Cisco C9148S MDS SAN switch or it not applicable, I have a storage with two MDS's at "Site-A" and UCS Server with one MDS at "Site-B" as the below figure:Please need to know if i can connect "SAN-2" with ...
Hello I have two Cisco switches 9500 and connected between them with one port and i need to adding another port to be as channel-group.I already create channel-group at each switch, so there is anyway to adding the active port to this channel without...
Hello I am just asking if i can using Nexus C3548P-10GX switch as SAN switch to be connected between the storage and servers.Appreciate your support Thanks
Should i ask the ISP to adding the below command under the interface. "encapsulation dot1q 300native" as the current only "encapsulation dot1Q 300" as belowinterface GigabitEthernet0/0/0.300encapsulation dot1Q 300Thanks
@MHM Cisco World Thank you for your feedbackWe cannot make any change at ISP router because its accessible from Internet provider only, so just can change the switch configuration. So can i ignore the CDP mismatch, or that will make any issue.Thanks
I configure them as access mode with VLAN for each ISP and working fine but getting notification "%CDP-W-NATIVE_VLAN_MISMATCH: Native VLAN mismatch detected on interface"So should i ignore it?Thanks
Thank you @Richard Pidcock if adding native keyword to encapsulation statement that will impact any traffic as its for ISP.Also if i ignore the mismatch error that will cause any issue.Thank you again
