Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings All,I hope anyone that anyone that is taking the time to read this can help me with my plight.We are getting poor perfromace out of our 10Gig infrastructure and I am not certain where the problem lies or where even to look. The network admi...
Greetings all,If I wanted to rename our active zonset called abc vsan 21 to xyz vsan 21 on our 9500 series mds. Doing this, should not cause an issue or knock anything offline?A collegue of mine was telling me that it may knock its zones and members ...
Hi all - I know you can rename zone sets. What would be the process of renaming zone members on a 9500 series?Is it even possible or do they need to be removed and then added with the new desired names?
Greetings, Iam a newbie to the san switch world. We have a MDS 9500 san switch and I am configuring and have questions about aliases. I see our older Cisco san switch uses device-alias, but the new one uses fcalias. Both commands seem to work on the...
Hi all - setting up NAC guest Server.I want to pull the sponsor users in from active directory group. I have set up to connect to a domain controller with success (test successful) and then added the domain controller but when clicking on the active ...
Perhaps I should of mentioned this.How can i do it with spending almost next to nothing.:)Anyhow There is a ACS appliance in the enterprise but not at my location (at about 100 miles away) we are connected via MPLS. But I know very little about the A...
True - but essentially every pc is going to be on that subnet.Chuckle I still need the answer to my initial question. Which is - what is the process to flatten the two vlans to 1? 1. Create vlan?2.Create Scope?3. test?anything else?please validate if...
Is this because to reduce the amount of broadcasts in a single subnet/vlan? Just looking for clarification on a 22 bit mask vs the 24.There is potential to have more then 500 hosts in this vlan.You are providing excellent suggestion regarding perform...
Hi Jon,there is no longer an expand device on the network that was something they were testing. That config needs to be removed. Thanks for pointing that out.However the objective is to make this easier to manage. The current setup is not. The enterp...
