Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have two router , conneted with dual WAN , both are from different vendor. We want to run EBGP as protocol.We need to sent some traffic through one link and some from another but when one link will goes down the other one needs take care of all ...
Dear All,We have cisco 2911 /k9 router, recently i purchased a hwic 2 t card and after installing it We have observed that while we switch off the network device attached to serial 0/0, port still remain up. We have tried with switching off the route...
Hi all,I experienced high cpu utilization in my chassies since last week.For troubleshooting As per the show process CPU output one of them process (Cat4k Mgmt LoPri) is taking max share of the CPU (80.51%).And based on Show platform health output we...
Hi All,We have 2 nos wlc 5508, One of them with 12 ap license and other with 25 ap licesce.Now I am planning to deploy both controller in same subnet and want to associate 10 ap from first and 15 ap from second.So can any one suggest me about this ? ...
Hi all,Let me know the procedure of IOS upgradation for 4948E.I have 4948 e series switch with cat4500e-lanbase-mz.122-54.SG.bin and now I want to upgrade this with ip base .Is it possible to upgrade lan base image to IP base in Cisco 4948E.
Hi Reza ,we use encapsulation PPP.I think the below mention detail give you more Idea to know the problem....1. We have 2 leased line connections. One from BSNL for which is connected serial port as PRIMARY and another one is Aircel link connec...
Hi Karthic,It's really knowledgable for me but I had a little bit confusion about the output which i had posted.There is datak9 services in both ( permanent and evalution).MPSPRI#sh licen allLicense Store: Primary License StorageStoreIndex: 0 Feature...
hi rocco.scholz,Our end users were connected through these ports but due the problem i had remove them and restart the switch.Now the problem is that the ports were randomly not responding and within 7 days total 5 nos ports were useless.Even I had c...
Dear Rocco.scholz,please find below mention output ....show interfaces gigabitEthernet 0/12GigabitEthernet0/12 is down, line protocol is down (notconnect) Hardware is Gigabit Ethernet, address is 0023.abe2.440c (bia 0023.abe2.440c) MTU 1500 bytes, ...
