Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Support team,We are on 16.9.3a but we seem to be hitting this bug. Can this be confirmed if this code is getting affected with this bug too ? Because we do have DHC snooping, and I was seeing device bindings on our trunk Port-channel, as soon as I...
Hi Community,We have an ISE 2.2 deployment where we have AUP enabled in the network. We store the endpoint MAC addresses in a Endpoints Identity group container once any user accepts the AUP.We had enabled AUP for some time and then we disabled it an...
Hi Community, I have ISR 4331 with 3.16 IOS-XE with 4 port switch module ("NIM subslot 0/1", DESCR: "NIM-ES2-4").Router acting as layer 3 switch.The downstream access switch connected to port Gi0/1/0 on the Switch module is not seen as cdp neighbour ...
Hi Cisco Experts, So, Is there a final settled code at for the PoE Issues faced by 3700 or 380 APs or Cisco IP Phones etc.Has anyone got a confirm solution on whcih IOS code has the issue been fixed ?We have 200 odd 3850 stacks and as it was pandemic...
Hi mate, I am in similar boat, but I am getting the error as - LCsClient#identityCert(Map) error while doing network mode registration of new local account. I did the curl test and that was all good. the on-prem server connect to cisco but the abov...
Hi Cisco community group, We are having a similar issue.Our setup is as follows: We have visitor SSID on WLC which is not in DMZ. We are doing AAA for visitor SSID on WLC using the external webauth using Cisso ISE visitor portal and the redirect URL....
Hi Paul, I had one question in the same context.If I want to block all communication between all hosts in the VLAN.e.g. block east west.but only allow north south from the hosts to internet or anywhere in the network.How will I be able to achieve tha...
Hi community,My question is the requirement for PxGrid way to get ISE and Cisco DNA to connect is Note: The recommended ISE version is 2.3, patch 5 or ISE 2.4 patch 5. But , my ISE is 2.2 path 9. So, what is the procedure to get ISE and DNA to co...
