Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks,This evening I tried mocking up a design to create a VPN across our Corporate Network from the Outside Interface of a Cisco ASA 5505 (Remote Site) to the Inside Interface of an ASA 5510 (Local Site).However because I was trying to commun...
Hi Folks,This evening I tried mocking up a design to create a VPN across our Corporate Network from the Outside Interface of a Cisco ASA 5505 (Remote Site) to the Inside Interface of an ASA 5510 (Local Site).However because I was trying to communicat...
Hi folks,Is it possible to use the 3560E-12D-S as an access layer switch to connect 10G servers via the X2 10G modules?One of our subsidiaries has bought one already and asked me to deploy.To be honest I've never seen any aggregation based designs I'...
Hi folks,Has anyone had any experience setting up Netflow from the 7010 platform to Solarwinds?I implemented the following code on both of my cores (VPC/HSRP Redundant Linked Pair) but had the following issues:1. One of the cores I could see was send...
Hello,I recently was asked to turn a routed link between our HQ and our DR Site into a trunked link to allow us to span our main Server VLAN up to the DR Site.I was informed by the ISP that owns the 100Mb Leased Line between the sites that the link w...
Thanks for your response Ajay. Have been given the following solution (a post on an incorrect board) which Im going to trial on Saturday in the lab but please review in the meantime:Create a new network segment inside your network (such as extranet ...
Hi Rizwan,Just to confirm I would create this Extranet on my Core (not the firewall) and add the Inside interface to the VPN ACL on the Local FW?I would then create a static NAT on the Local FW from my Inside Local Address to the Extranetwhen the sou...
So another update.Today I basically tried creating the trunk link again today but what I did was create VLAN15 as I normally would any other VLAN. An IP Address on each of my cores and then an HSRP Address for it.When I trunked the Link over my switc...
Great thanks Marcus,Tomorrow morning Im going to try and set this up again but Im going to try and simplify things by removing the IP Routing from the 2 switches involved in the connection so they are only dealing with L2.I can move the routing for t...
