Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
dear all:in fact we use Cisco encoders with VICON PTZ camera , but the encoders doesn't support the vicon camera model (SVFT-W22CA-C)? any support.smadi
Hi there,I just installed the Cisco Unified Presence Server and am able to see the server in Call Manager (Under Application Server), it came in automatically over there (note: If i add a URL or End User URL and save it, it does not save these change...
Referring to the topology in the attached diagramI would like to know how it is possible to send a fax from Site B (Branch) using the PSTN line of Site A (Head Office) over the WANWhat are the commands and configurationI can make phone calls over the...
I'm facing a strange problem or maybe its because of my lack of knowledge of the NANP.I have only one route pattern @# and i dont have any dial-peer in the gateway that matches a number starting with 4 at all... but strangely when i dial any 7 digit ...
Hi there,We have three departments in our organization that have managers that need access to mobile's but "with different codes" to be able to access dialing mobile numbers...I did the following and am noticing a strange behaviour, any indications a...
connect a pstn line to the fxo port and run the following commandterm montest voice port 0/2/0 si-reg-read 29 1do the above for bot the voice ports..you will get an output like 0x00 or 0x.. (where .. is some digit or number but other than 00), if you...
Hi Mohammed,I'm assuming you have cucm setup with ip phones registered, as you've not mentioned the details...In a company i configures connection plar opx 333 (receptionist) temporally instead autoattendent......1- when i call from outside ( eg. fro...
oops i added an extra "-"try thisterm montest voice port 0/0/0 si-reg-read 29 1for all portstest voice port 0/0/1 si-reg-read 29 1test voice port 0/0/2 si-reg-read 29 1test voice port 0/0/3 si-reg-read 29 1you should get an output of 0X00 or 0XNN (wh...
oops, the output of your show dialplan shows two dial-peers 787499872 & 7874998 with the same destination pattern and preference level to the pub and sub (i suppose), change the preference of one of these dial-peers to 1, other than that it should go...
