Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi alli know it is a native question.but can any one help me understand how the best effort worksif i have a link of 2Mbps , and customers are sharing this link having differnet speeds from 256K, 512K,1M,and 2Mhow will the traffic be distributed amon...
Hii just want to make sure of something..does the command or the feature of ( neighbor x.x.x.x next-hop-self )works for the IBGP sessions ??i mean does an IBGP neighbor change the attribute of the next hoop when sending a route to an IBGP neighbor..?...
Hii am having a network of multivendors, Cisco and other vendor routers.i am running MPLS on the network and when i run MPLS in the Cisco part, problems arise.MPLS is not working well on Cisco Ethernet segment, and i have a 7206 router connected to a...
Hii want to switch a PPPoA session on an intermidiate 7200 router (doesn't terminate the PPP session) that have an interface STM1 ATM facing the DSLAM, and another Interface E1 frame relay facing the IP terminator.can anyone help how can i make this ...
what about if i configured two EBGP sessions with EBGP multihop (for load sharing on the 6 pathes)where each BGP session is established based on a different Loopback interfaces, i.e. Session one between loopback 1 on my router and loopback 1 on custo...
Sir, i know it is possible to load share BGP up to 6 lines..but i have 15 one !!if i replaced the 15 ports with an E3 port and a MUX for physically grouping all of the interfaces, will this be usefull and BGP will treat it as only one Path and a MUX ...
siras far as i understand..u want to pass some traffic from area 1 to area 2 without changing areas..right??well if this is so , may be you can add static routes on the link between the two areas, for just the traffic directed from an area to the oth...
Hi Natyes to a great extent u answered my question, and to confirm with you i will state the following:i will use LDP for normal MPLS labeling, and in case i will use MPLS TE , i shall use RSVP for signaling the TE tunnels.right.??:)RegardsMohamed
