Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am trying to migrate an EIGRP network to OSPF. I thought I would do this by enabling OSPF across the network with admin dist of 180, then drop the AD on the Area 0 routers to get OSPF working in the core, then do the same in the leaf areas. ...
Hello,I want to use Multiprotocol BGP VPNV4, but I don't want it to send labels in the MBGP update for the routes, however I can't find a way to stop the labels being sent. Can anyone please tell me how to strip/remove/stop the labels being attached...
Hello,From reading theh command reference, when I configure arq reject-unknown-prefix on a gateway, and gw-type-prefix 1# default-technology; the gw-type-prefix.... command is effectively disabled, since it is only used for unknown prefixes, and the ...
Hello,In multicast the (*,G) group entry will be dense mode if there is no RP for that group. If the interface is configured as ip pim sparse-mode (i.e not using the automatic mode of ip pim sparse-dense), does this mean that traffic is not forwarde...
Hello,I have a PA-4E1G-120 balanced card in a 7500, which has DB15 connectors. The carrier has provided an RJ48 presenation. Therefore, I need an E1 balanced cable from DB15 to RJ48.The closest match I can find is the CAB-E1-PRI/NT, DB15 to RJ48C f...
Hello guys,Thank you very much.I had always been told that EIGRP and OSPF were ships in the night routing, but it looks like that is not the case, since EIGRP makes decisions based on whether its route is the route in the main routing table or not, c...
Hello,Thank you for the link, it looks interesting.I am looking at the config example - http://www.cisco.com/en/US/products/ps6604/products_white_paper09186a00804fbfac.shtml#wp1065448It shows a PE that has customers connected on POS1/0, and based on ...
Hello,Thank you for your reply.I should have explained that R3 represents a core/global IPv4 network, that I can't make any changes to. All I can do it send it IPv4 EBGP routes.Therefore, in response to your points about R2 not knowing which VRF to ...
Hello,The main reason is that I don't have the option to have MPLS in the middle of the network, whether natively, or tunneled over GRE/L2TP.I want the green VPN at site A to only ever see routes for the green VPNs at the other sites, and MBGP with r...
