Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In a lab environment I have 1 WAE 612 (4.0) Control Manager and 2 WAE 512 (4.0) with a Transport License.Af first I want upgrade all at 4.1 and go to Transport to Enterprise.First question: for the 612 is it sufficient an upgrade to 4.1 maintaining t...
We are configuring an IPt network. the switch is a 3750 and the phones (5) are 7942. the strange is that 4 phones are ok while the last phone is not able to get an ip address and the configuration. the DHCP is in the UCM. The port where is connected ...
I'm configuring an AP1130 AG with two vlans: one for the managemement and one for the WiFi users. The customer does not want to use the VLAN 1. I created radio interface 0.<management vlan> and 0.<WiFi VLAN> using two specific bridge-groups (differen...
I'm configuring some AP 1130 AG. For customer requirements I cannot use the VLAN 1 but in particular a VLAN 102 for the management and the VLAN 117 for the WiFi users. At this point I configured the switch port in trunk with the vlan 117 and 102 as ...
Hello,I have a LAP1252AG-E-K9 managed by a WLC embedded in a Catalyst3750G. My question is the following: how can I disable the 5GHz radio module using the WLC (I desire leave only the 2.4GHz module). In addition : in case I put in the LAP only 3 2.4...
Hello Dan,thank you very much. A last question: if I want upgrade my WAE CM from 4.0 to 4.1 I need an Enterprise license (that includes the CM features). My doubt is: when I will update it a 4.1 I will need also a license upgrade from transport to en...
Thank you very much!Here a piece of the conf:interface Dot11Radio0 no ip address no ip route-cache ! encryption vlan 117 mode ciphers tkip ! ssid XYZ ! station-role root bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 block-unkno...
I will made some test /debugs for see what the router receives from the cluster. I don't know well how the cluster runs but when there is the swap is not it that must send a message to router for update this arp cache? What type of debug can I perfor...
