Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we're working on a new network...PIX 515e with 128M ram. We are seeing dropped connectivity and noticed the problem happen when the xlate count hit 49000. We clear xlate and the problem goes away for about 5-10 minutes. Is there any way to increase t...
Is there a way to be notified when you have a new MAC address in the arp cache? I have a remote router, usually a 1720 or a small 2600 router with no managed switches. If I had a managed switch, I would look for a link up trap. I need to know when a ...
Can I have the data logged to syslog be level 6, but the data stored on the switch be level 4 or 5?I'm managing several IOS and a bunch of CATOS switches. We're using Ciscworks and have the logging level set to severity 6 for everything, so Ciscowork...
I have an environment that has a lot of radio noise. Some from signals bouncing around in a manufacturing environment and another site where we have neighbors who are using the same 11b channels of 1,6 & 11. I'd like to tune the RTS settings in order...
A.Awan thanks for the reply ...Looks like that works for IOS, but on the CATOS side w/7.6(6), I don't see the same extentions to the set logging command. I can set the buffer size, but not the severity. I can set the logging level all , but that's wh...
David, checkout the NEMA boxes from Hoffman. I purchased 16 NEMA1 boxes last year and mounted AP1200's in them. The one we used was Hoffman #AHE12X12X4. Its 12X12X square and 4 inches deep. No lock or clear cover, but it only cost $12.50. You can get...
I used that document to setup the access points. We did find one problem today. We saw where one active access point's radio was down and the hotstandby became active. We saw were the LEAP authentication failed between hotstandby and active, so that'...
Thanks for those procedures. I was partially there...We are moving to the 64M ATA Flash cards on some of the switches. That requires you to have the 7.1.1 ROMMON installed on the switch. Thanks again!!JR
