Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a H323 gateway with an E1 PRI interface. Twice in the past 2 months I have had the problem where no inbound or outbound calls can be made. Upon checking the 'debug isdn q931' statistics I can see that one call is looping out taking up all th...
Hi,I read an article saying as of IOS release 12.2(11)T MGCP endpoints can be configured to become h323 endpoints when SRST mode is operating due to a WAN failure.My situation is the following; I have several remote sites all with local MGCP 6608 gat...
I am experiencing the same problem and it appears to us that it occurs when the dialed destination is busy. What version Callmanager do you run and what firmware is on the phones, we are running version 3.3.3(sr4a-es46) which is an engineering speci...
Hi Kevin,No solution but I have experienced the same problems. We have 49 remote 350's connected to Cat2950's. We have been experiencing intermittent dropouts of access points with certain units seeming more prone than others. We have been finding...
We have experienced this problem as well and in the end we found the cause to be that we used a "%" in the password. Try to avoid using underscores and hyphens and other symbols in your partitions, calling search spaces, and so on, as it can make th...
Your console port may be configured for a modem. Is there any output to your terminal emulator when you connect the console cable. If messages like ATQ0H0 appear this is the case. Try rebooting the switch and holding down the mode button. From he...
