I have a L3 switch with several vlan interfaces. I want to add another vlan interface that is restricted (isolated) from the other vlans. What would be the best way to go about doing this? Should I create an extended ACL and then apply it to the V...
How do enable the 837 box to provide a dmz and use that interface for the IP of the dialer0 (ip unumbered)? then configure the other (ethernet0) interface with a private ip address for the internal network. Through the SDM web interface the dmz con...
Heres what I'm looking to accomplish. We currently have 2 T1's with a CIR 1024 per T1. I would like to setup traffic shaping to handle congestion. What would be the best way to go about this? Or, where should I start? We are currently utilizing C...
I enter this AT command below:at+MS?+MS: V92,1,300,48000,300,56000And this is what I get even after I enter the at+MS=v32b command. Just some further information.Regards,Joel Metz
debug output below:Modem 1/2 ACF: Event: CONNECT V34/LAPM/NONE/28800:TX/26400:RXWith the above command initiated. I need to connect at 19200 or lower.Any help would much be appreciated.Thanks.