Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I want to add the following Bash commands on a Nexus switch. Will there be any impact from adding them?Switch(config)# feature bash-shellSwitch(config)# endSwitch # run bashbash-4.4$ cd /mnt/pstore/stats_ssdbash-4.4$ ls -ll Thanks in Advance
Hello Everyone,One of our Nexus switches failed and requested an RMA, the primary switch is good, and the second failed. if i configure the RMA switch and connect them as it was before, will the primary reload as well or just the secondary join the V...
Hello,We have 2 Nexus 9Ks one is primary and the other is failover/Secondary and are not stack. I want to upgrade the ios on both of them so can I upgrade on the secondary switch and then upgrade the primary or vice versa. Do you know if the other sw...
Hello Everyone,In our data center, we are currently using a 3850 as our internet switch, what is the best replacement for it within the $2.5k to 3k? It should support layer 3 routing. Thanks
Hello Everyone,We are having 2 neighbors on BGP with different ASNs on each neighbor. Is it possible to load balance the traffic on 2 neighbors? If yes what configuration will help to do the same. And also not seeing any traffic on second neighbor du...
Hi MHM,Here is the outputInternet switch#show ip bgp 0.0.0.0BGP routing table entry for 0.0.0.0/0, version 34Paths: (2 available, best #2, table default)Multipath: eBGPNot advertised to any peerRefresh Epoch 112xxx, (received & used)66.xx.xx.197 from...
Hi Harold,Thank you for the response, these command will restarts the BGP sessions right? Is there any other way that avoids the restart of current BGP sessions? TIA
