I would like to know if there is a way to set the port state to any of the available states.Say I want to force a port to be in the Listening mode all the time.Thanks
I need to to configure STP to act a specific way and have not done this before. The design and need is as follows:I have 2 6509s(A&B) and 2 4506s(C&D) configured in a loop. And need to force B to be the root bridge and block traffic between A&B. Al...
Is there a command that will show the port speed on all ports of an given module. not using sh intexample. Say I want to make sure all 48 ports on mod 5 are running 1000 fullappreciate the help
I am trying to add a 3rd IP range to a vlan, that already contains 2 ranges, on a 6509 switch. If anyone knows how this can be done I would appreciate it.Greg