Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My AP1852 reboot loop and can't join WLC. I tried update image, but failed. The info as below.(Cisco Controller) >show ap join stats detailed d4:2c:44:e6:e1:40 Sync phase statistics- Time at sync request received............................ Not appli...
My 1852i disconnect from WLC. And I start it display below. Sometimes need to input new username and password\ SSID, but I can't save it. And it automatically loop restart. Start the indicator is solid green. After a while blink green, and then blink...
My 1852i disconnect from WLC. And I start it display below. Sometimes need to input new username and password\ SSID, but I can't save it. And it automatically loop restart. Start the indicator is solid green. After a while blink green, and then blink...
Thanks for your reply, abedalmawlaitani.I have fixed this, but my configuration is different from your.1st, I didn't find the advanced mode.2nd, I enable the fast lane.3rd, in option "advanced" 802.11k enable(default), 802.11r adaptive(default), 802...
Today I config the same configuration on both real 3560 and 2960. And they can't ping mutually.Catalyst3560：interface GigabitEthernet0/1 switchport access vlan 21 interface Vlan21 ip address 172.16.0.1 255.255.255.248电脑172.16.0.5/29，可以ping通。 interfac...
The same configuration on both catalyst3560 and they can ping mutually. I do not think the catalyst 2960 support ipv6 on Cisco packet tracer.Thanks for your help.
