About rogalskij

rogalskij · 05-02-2025

We have several Cisco 2960X switches, and we would like to more closely monitor temperature on the units. Is there a simple way to change the temperature output to Fahrenheit instead of displaying it in Celsius?

rogalskij · 05-30-2024

We have a 2 switch stack, it consists of one Cisco C2960X-LPD-L as the top of rack, and a member stacked to it, a C2960X-FPS-L. It has several POE phones and cameras attached to both, and all are working except a few. I tried moving the port to seve...

rogalskij · 05-23-2023

We have a Cisco Unity server currently on version 12.5.1.16900-29. When we try to upgrade the firmware (or even transfer .cop files) the normal way we always had, we get an error stating "The user name or password is not valid". We are positive the...

rogalskij · 04-11-2022

We have a Cisco 2960S-48FPS-L switch with a single port that refuses to enable no matter how many times I run "no shut" on it. Even after defaulting the port to factory settings "shutdown" still shows in the running config. Tried rebooting the swit...

rogalskij · 03-21-2022

We have several Cisco 2960X switches of varying models all with the same GUI problem. At the top of the GUI on the status bar, the information doesn't render correctly and instead displays variables and characters. This is happening to all of the 2...

rogalskij · 03-27-2025

I have had luck when the switch fails the memory test and goes directly into "bromode". Not every time, but a couple times if I removed the stacking module and the GBIC from the system entirely and powered it back up, it came back. This wasn't the ...

rogalskij · 01-03-2025

This worked for me as well. I already had the priv level for my user account set to 15, but adding the "ip http authentication local" fixed it immediately. Didn't even need a reboot. Thank you very much!

rogalskij · 06-05-2024

Rebooted the whole stack and no change. Planning to re-cable the unit sometime next week when there is downtime. Will post more info then. It is a remote site so more planning for outages is necessary.

rogalskij · 06-04-2024

Attached is the file with show ver and show switch

rogalskij · 05-31-2024

And addtiionally "sh env power" displays no issues. I don't quite get it. switch#sh env power allSW PID Serial# Status Sys Pwr PoE Pwr Watts-- ------------------ ---------- --------------- ------- ------- -----1 Built-in Good2 Built-in Good

Member Since	‎01-03-2018 01:30 PM
Date Last Visited	‎05-05-2025 02:06 AM
Posts	36
Total Helpful Votes Received	25

User Statistics

User Activity

Change 2960X switch temperature output to Fahrenheit.

POE issue with C2960X Stack

Cisco Unity SFTP firmware update fails with username error

Cisco 2960s port stuck on "disabled"

2960X Switch Web GUI text and character issues

Re: 2960-X stalls on memory test during bootup

Re: CSCvo35537 - C2960XR-48FPD-I reports "Cisco {{platform}} {{de

Re: POE issue with C2960X Stack

Re: POE issue with C2960X Stack

Re: POE issue with C2960X Stack