Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
we have many APs on first and second floor but we are observing many users connecting on second floor AP12 only.
FYI, we have DNAC, Prime tools in place.
please suggest
for icmp, there are no flags in ASA under show conn outputs, but i observed one thing that if i ping from source (inside) to outside then i can see inside 10.1.1.10:5 (:9) always incrementing whenever we initate ping and destination ip:0 is alwa...
hello,
i am unable to ping from R7 to R3 and vice a versa
please help why nssa to nssa is not pinging
i configured default-info originate always command but still i cannot find default route in route table nor i am able to ping loopback ip.
Hello,
first two vEdges were onboarded manually by setting up Ip addresses unde vpn 0
third vEdge, i am trying to onboard using prebuilt templates but under vmanage-confg-devices, its showing synch pending, device is offline
what could be an issue ?
Hi Scott,
Yes, I’ve visited the building. It primarily serves as an open area or mega event space, where you can see all seven floors from the ground level.
Access Point AP12 is located on the second floor, and there are 4 to 5 access points on the f...
like if we see UIOB that means outside to inside and without B UIO inside to outside, we can identify from which direction traffic initiated but for ICMP we dont see any flags so can we conclude as per above message ?
Hello MHM,
i configured default info originate always under router ospf 1 on R1 and R5 (ABR)
i configured area 2 nssa default info originate command on R6 and R4 (ASBR)
but still i cannot see default route in nssa areas therefore i cannot reach R3 ...
Hello MHM,
I need to configure default originate on IOU2 and IOU5 as per above and see if default route getting generated or not...
Thx MHM I will come back today EOD
