Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have purchased MS390-48UX 2 of these switches along with our MX95. I am wanting to stack the 2 switches together. I have also purchased the Meraki MS390 120G Data stack cable. When I connect these to each switch in a ring topology I then go onto...
Hi,
Wondering if anyone could shed some light. We have around 30 Cisco switches SG350X-48P. Due to on-going cyber security we are looking to update the switch firmwares. Unfortunately when I look for the firmware I am presented with different versi...
Hi,
I currently have 28 Cisco SG350X-48p switches. These switches have different Vlans for our customers. We currently have a printer which is connected via the public ip. We would like to instead allow our customers to access this printer via our ...
Hi,I have recently upgraded our sites Wi-Fi from MR33 to MR36. We have about 20 APs spread out. We have been having on-going issues where clients are getting disconnected from the internet but show connected to the Wi-Fi network. When looking at the ...
Hi,
I have installed and setup a new Cisco 2069 switch and joined to our domain. recently I have noticed that Vlans have not copied over to this particular switch. I have created the Vlans on the core switch and all other switches have received thi...
I think there last resort was to factory reset but unfortunately this cannot be done to live production network and downtime is very limited due to users working overnight
Hi Bradly,I’ve been having some issues with this onboarding and it looks like my switches are not removing the config correctly.would you be able to share with me the script you have used to manually clean up the old meraki config. I have support tic...
Thanks Dan. The packet captures shows no issues with 802.11v. It seems the issues seem to be MacBooks which is wearied as apple Imacs and other iOS devices are fine.
