Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Do the settings under "Scan Behavior" take precedence over the settings under "Mail Policies: Anti-Virus"?If we selct No Actions under:Actions for Unscannable Messages due to decoding errors found during URL Filtering ActionsActions for Unscannabl...
Hi,At this time we only mark potential spam messages.Now we want to use the Spam Quarantine.Is it possible to notify the recipient without connecting to a ldap service?
Our Default Destination Control has TLS required because of the dsgvo/gdpr.
How can we configure the system to transfer all outgoing mail from one specific sender (newsletter adress) not over TLS.
Thank you for the helpful instructions.Unfortunately, our SG350XG switches show the status “Disconnected” in the Settings . What else needs to be activated in the switch? The switch and the CBD are on the same network. There is no firewall between th...
We do not use the spam quarantine.We use an content filter to modify the subject of all spam mails, send them to a policy quarantine, and send a notification to the EnvelopeRecipients.It is safer this way.
OK, Thank you.We don't want to Enable End-User Quarantine Access.We only want the spam notification to all recipients.If we configure the Notification for all users, we must configure "Deliver Bounce Message To:"But that will result in no one getting...
