Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear I have an ASR9910 router with 4.4KW power modulewhen wiring a single source the command #shwo environement power-supply# gives me input only 2,2Kw (in my exemple I have 3 power modules with 4,4kw for each one)is that to have 4,4Kw I have to wire...
Can an ASR9K work with two modules of different version?for exemple I Have ##################NODE power-module 0/PM0/SP 2kW DC Power ModuleMAIN: board type 0xf0038aS/N: DTM173103UETop Assy. Number: 341-00400-02PID: PWR-2KW-DC-V2HwRev (UDI_VID): V01Ch...
Bonjouren transmission j'ai la situation dessous Optical Optical
Temperature Voltage Current Tx Power Rx Power
Port (Celsius) (Volts) (mA) (dBm) (dBm)
--------- -------...
I swaped RSP 1 to RSP 3 on The ASR-903 with RSP-1 can handle IMA1X in slot 0 and 1 and 2, when we swap to RSP3 the IMA1X is handled only in slot 0 and slot 4 if we use IMA8S and IMA8S1Z on all slots refering to cisco documentation, but when we apply...
[cid:a6880b10-edd4-425c-a663-c5baef8d6059]What about this module it s for CRS or cab be used also for ASR9K?________________________________« Ce message et toutes les pièces y jointes sont susceptibles de contenir des informations confidentielles ou ...
CSG-65-01#sh run interface gi0/4
Building configuration...
Current configuration : 320 bytes
!
interface GigabitEthernet0/4
description link_FO_to_ME-34-01
dampening
no ip address
load-interval 30
carrier-delay msec 0
media-type sfp
no negoti...
