About Meri Christmas

Meri Christmas · 09-03-2019

I am configuring six 3850's 48p F-S. They will eventually be a stack but for now I have updated the IOS to Denali 16.3.9 which was tough because some of the switches I received would only boot to rommon (switch:) and only a few would boot to the IOS ...

Meri Christmas · 12-05-2018

Good Day All I am fairly new to networking. I have a question about clustering. We have two different catalyst switch models: C2960X and C3850. We currently are using both in one of our offices on different floors i.e. 3850 is our core on one floor w...

Meri Christmas · 04-18-2018

Good Afternoon My company has set up a new office, I will call "Central". We configured a 3850 switch connected to a ASA 4406 firewall. Every is working fine except for one problem. I can't connect to printers, servers, or computers in our other ...

Meri Christmas · 03-29-2018

I have a 3850 switch connected to a 5506 ASA But when I connect a pc to the switch I can't get internet access. The switch can ping the firewall, the ISP's gateway and pretty much anything on the internet. But I cannot get internet access when I con...

Meri Christmas · 03-28-2018

Our ISP has set up a modem at our location with the following IP and subnet: ip 96.74.187.50 mask 255.255.255.252 I'm trying to put in an ip route to the next hop which is our firewall switch> ip route 96.74.187.50 255.255.255.252 10.10.22.5 when I d...

Meri Christmas · 09-04-2019

Will do and thank you again!

Meri Christmas · 09-04-2019

I changed VTP to transport then created a test vlan 3. Then I did a sh vlan and I saw it! VLAN Name Status Ports---- -------------------------------- --------- -------------------------------1 default active Gi1/0/1, Gi1/0/2, Gi1/0/3Gi1/0/4, Gi1/0/5,...

Meri Christmas · 09-03-2019

Yes I can definitely do this and let you know. Thank you so much!

Meri Christmas · 09-03-2019

Unfortunately I don't have a show vlan brief as I am not at the switch (I should have copied one before I left the office for the day), but I do have a show run. It's not fully configured. I stopped when I realized I couldn't see the vlan's I created...

Meri Christmas · 04-18-2018

OK now my "saving routes" issue is resolved. The switch only holds 16 routes. I removed the routes that we no longer use (from locations that don't exists anymore) and added the new ones. DONE! Thanks much. I'm a newbie so I will probably have ...

Member Since	‎03-28-2018 01:44 PM
Date Last Visited	‎01-29-2020 07:34 AM
Posts	16
Total Helpful Votes Received	5

User Statistics

User Activity

Show Vlan command does not show all Vlans

Cluster Catalyst 3850 with 2960

Can't Connect to Systems in other Office Locations

No Internet Access After Configuring Cisco 3850 Switch

%Inconsistent address and mask

Re: Show Vlan command does not show all Vlans

Re: Show Vlan command does not show all Vlans

Re: Show Vlan command does not show all Vlans

Re: Show Vlan command does not show all Vlans

Re: Can't Connect to Systems in other Office Locations