Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Day,
I'm updating a QoS policy for a bunch of tunnel interfaces that we run over our WAN service. Each tunnel connects to a remote site which has a 5M internet service. Below is what I have as a standard policy that I apply facing the site (Down...
Hi,
I have a C210M2 UCS server in a RAID configuration which now has a failed drive. I have a replacement (Spare) drive (same part number) that i'm ready to swap in to the system to replace the faulty one. My question is: does it matter what data is ...
I have a test enviornment with AnyConnect set up and I can log in and it all works fine. I'm now trying to play around with hostscan, to check for a simple registry key entry on the client machine. I think i've set it up as per the documentation, but...
Good Morning,I'm pretty sure my issue is with the telco, but I wanted to see if there is anything else I should be debugging/checking also.A site has an 1861 with 3 POTS lines. For the past few weeks, they have been missing calls at their site. When ...
Good Evening,I have an ASA running 8.6(2) and we started seeing an issue with one website last week where users reported that it was operating 'slowly' and sometimes they wouldn't get a connection at all [Page cannot be displayed]. Looking at our fir...
thanks for the replies. The spare (used) drives I had were actually in an unused UCS chassis so I went into the LSI config and removed the RAID configuration, so all drives were 'Unconfirmed - Good'. I've swapped the drive and it's now rebuilt.
to update, when I browse to the webvpn (clientless) external site of my test environment, it now first installs CSD (hostscan) prior to presenting me with the login page.. this is the opposite of what i'm looking for though, as I expected it to downl...
Just to update, AT&T came to site and cleared the lines. Internal wiring tech also tested lines ok. After moving the cables around the problem stayed at the FXO port and not the copper (a 'good' line was good only in a specific port, if we moved to a...
