Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
C9200-48p model from 16.12.2 version to the recommended version, 16.12.3a version, after upgrading,NM-4X module is not recognized.If you check on the equipment, there is no NM-4X inventory information in show inventory information, even if you check ...
n3k Set poap on initial build In question, you entered skip.I want to set it back to yes and set it to normal setup.I am wondering if it is possible to change the poap setting to Yes again when the device is already booted and configured with skip.
I...
n3k-c3172-tq-10gt The operating system of the device was started for the first time.
Version: 7.0 (3) I2 (2b)
Version: nxos.7.0.3.I4.8b.bin
--------------------------------------------------------------------------------------------------------First ...
Whether WLC QOS settings are applied
Applying the QOS settings on the WLC will determine whether it applies to each user, whether it is applied as an SSID,I would like to know if other standards apply.
As a result, I would like to know what standards...
Currently, the SW is a LAN LITE model and only supports single host modeUsing single-host mode,If it is connected as shown below
SW -> (single-host mode setting, mab, dot1x authentication setting) | |IP Phone -> (mab authentication, specific vl...
After upgrading to the recommended OS,I can confirm that the new version has been uploaded,I can not reboot and force a reboot,All configurations have disappeared.This event does not set the PW in the admin account after all, and the boot path is not...
Thank you very much for your reply.I understand that I need to set the PW of the default account admin.If so, I do not understand the message that comes out as an incompatible image in the OS version.These messages appeared during the installation pr...
I have never tried it.
If you try,
switch (config): username admin privilege15 password (empty)
I wonder if you should try this way.
I know that the default id / pw of the nexus admin account is id: admin, pw: empty (enter).
